Geeetech

Hey thanks for reply.

Finally i got it done and my first print is finished.



Thanks so much at all !

Okay, iot it nearly all done.


My last problem.
i'll heat my extruder to 200°
Put in the Filament (by pushing arm down)
and let the Extruder motor run, but nothing comes out of the needle.

anyone?

i only inverted X and Y Axes, now there turning into correct direction.


#define INVERT_X_DIR true // for Mendel set to false, for Orca set to true
#define INVERT_Y_DIR false // for Mendel set to true, for Orca set to false



found this also here in Forums.

now, after i set the home position at ...

Thanks much for reply,
i allready finished the build, but unpluged the endstops just for testing.

I heavent not set a home position after i set, axes move into bith direction.


now i have a nother Problem, for e.g. the Y axis only move for 30mm than it stops,
i think i need to check firmware ...

Hey. I habe the Same Problem with X and Y !


Can anyone help ?

Hey Ppl.

I have buid an I3 Pro B with the Board GT2560.

I can move all axes (XYZ) into only one direction,
even if i use LCD Panel or the Repetier Software.

19:22:35.213 : ok T:22.7 /0.0 B:22.4 /0.0 T0:22.7 /0.0 @:0 B@:0
19:22:38.275 : ok T:22.8 /0.0 B:22.4 /0.0 T0:22.8 /0.0 @:0 B@:0
19:22:41 ...

Hey Ppl.

I have buid an I3 Pro B with the Board GT2560.

I can move all axes (XYZ) into only one direction,
even if i use LCD Panel or the Repetier Software.

19:22:35.213 : ok T:22.7 /0.0 B:22.4 /0.0 T0:22.7 /0.0 @:0 B@:0
19:22:38.275 : ok T:22.8 /0.0 B:22.4 /0.0 T0:22.8 /0.0 @:0 B@:0
19:22:41 ...