Geeetech

Prusia i3 pro B Gt 2560. How long should I print without a pause? I have an 8 hour print ready but I was worried if the motors might get too hot.

Thanks

Hi when I turned on the printer this morning the Y axis worked fine for about 5 Minutes then stopped again. Could this be a voltage problem?

Hi, I just built my first I3 pro B, My axis motor working fine and then stopped, the motor works in the x axis slot on the board, i am assuming that the slot on the board is broken, is it posible to reprogram the pins from my empty 2 extuder slot to funcion as the y axis?

I am new to this and would ...