Geeetech

So, i have it:
At Power on my Printer is completly quiet. No Fan is running. Only when the Extruder reaches 50degrees the Fan for Hotend an the Board Cooler for the Gt2560 Starts up. After Printing when the Hotend is lower than 50degrees the both Fans stops.

You have to Change only two Parameters ...

Thanks for your reply.
I Seen the PWM Pin an i use it for layercooler.
It would be nice to have another One.
So i could shut Down the BoardCooler an the Extruder cooler after a print.

Hello Geeetech Support!

I just finished my Prusa i3 Pro B.

Is it Possible to Mount a PWM Fan on the Extruder2 Heater Pins?
In a other Printer i have a Ramps Board, and there is this Option, when i Configure it in the Firmware

Thanks for your Support.

Bernd