Geeetech

Flow rate being %100 or multiplier of 1. Depends on software. I think I read you were using up to 2 somewhere which is way too much.

Looked the video, looked like either it was bad ABS or temp wasn't high enough but your extruder was moving way too much for how much was coming out. Sometimes you ...

I think you may be using too high a temp for the heat bed. I am actually reducing the temp and getting much better results at about 70deg.

There is a good print model called the 3D Benchy which is a boat that has alot of features you can use to fine tune your print quality. Should be able to find ...

Hi,

Just trying to find the data sheets for the 2 different motors used on the Prusa I3 X 3d printer.

I have fitted the DRV8825 motor drivers and wish to know the maximum amp rating for these so I may set the reference voltage correctly.


Thanks.