Geeetech

Hummm… i attached a year ago the new version marlin 2x for all DIY Geeetech printer and forum continues with 1.1.8 marlin version..

Te paso varios.

Hi All,
I've attached the Marlin 2.0.5.3 release for Geeetech Pro W. board GT2560 Rev A+
It has BL Touch configured.
My BL_Touch is in front my noozle and left (https://www.thingiverse.com/thing:2329594).

**You need to use latest arduino IDE (today 1.8.15)

If you need to change the BL Touch ...

I set all drivers to 1.1 I dont know which one is for Z axis.. xD.. Thanks!

How can I check the voltage?

Thanks!

Hi william,

which A4988 I should to check? there are four.

Thanks!

I have a little problem with left T8 screw. before send to print I check the altitude from both t8 screw and the left It is always behind than right. Then I put a same altitude for both screws and I print the piece and then when it has finished the left is another time behind the right so I dont ...

ok, I have was able to configure bl touch in Marlin 1.1.8
I have follow these instruction from a youtube video.
https://www.youtube.com/watch?v=y_1Kg45APko&t=0s&list=LLuaA3y639BwfDUrURqulQ_A&index=1
My problem was the 7 step. I thought that M851 Z-XXXX was the nozzle offset, but it wasnot

Z ...

To move Z axis I use the LCD with Prepare>Move>z Axis>0.1mm, I use Repetier Host to send commands and then send Z Home to check altitude.

Hi,
Attached my Firmware. I use the repetier host to move Z axis and send all commands.

I've tried with:
#define Z_PROBE_OFFSET_RANGE_MIN -20
#define Z_PROBE_OFFSET_RANGE_MAX 20

and

#define min_software_endstops false

The lastest is the same that "M211 S0" command I think, but I hardcoded in ...