Geeetech

hello sorry for the delay.
this happens near the end of the print. In the meantime, I changed the heating cartridge, but it is still the same

how to measure at the end? when I dismounted, the temperature given by the probe is equal to that of the temperature of the piece and when I put it in the fingers, it goes up ... apparently it reacts correctly ...

Hi,
If thermistor disconnect, the message is différent (i have testing)

=> i am trench

Actually, print stopped because the lcd message is (look picture)
==>> TEMP IS TOO LOW....

After this message, the hothend cooldown ans print is stopped...

Do you have hello for me ?

hello, following the purge tower which is shamefully filament filth, I wanted to test under cura the purge basin, but apparently cura does not want to take it into account!
I deactivated the primary tower, but it still goes to its location
(test performed without filament to avoid unnecessary ...

hello, I call for your help under cura.
I installed the profiles downloaded on this forum, but when I try to print in two colors, the color change is not clear and sometimes it's even gradient.
I changed the volumes for the tower but I do not really see the difference.
could someone tell me his ...