Search found 3 matches
- Sun Nov 24, 2019 12:33 am
- Forum: Geeetech A20M
- Topic: TEMP TOO LOW
- Replies: 9
- Views: 14820
Re: TEMP TOO LOW
Hi, this is me. Very sorry about the delay. It seems I have fixed the problem by changing the start and end gcode to what it is supposed to be for Marlin. When I start the print it works just fine but then I came downstairs and noticed that the printer head was "printing" but no filament was coming ...
- Wed Nov 20, 2019 9:04 am
- Forum: Geeetech A20M
- Topic: TEMP TOO LOW
- Replies: 9
- Views: 14820
Re: TEMP TOO LOW
- Print4.jpg (148.74 KiB) Viewed 14803 times
- Print3.jpg (148.48 KiB) Viewed 14803 times
- Print2.jpg (161.27 KiB) Viewed 14803 times
- Print1.jpg (168.37 KiB) Viewed 14803 times
But then when it starts the E1 requirement drops to 0 and then it stops and displays TEMP TOO LOW.
- Tue Nov 19, 2019 10:16 am
- Forum: Geeetech A20M
- Topic: TEMP TOO LOW
- Replies: 9
- Views: 14820
TEMP TOO LOW
I have sent an email to the help service which still hasn't replied. I have an a20m printer and whenever I start the print it heats up properly, however, then goes to center, goes back to auto home and displays "TEMP TOO LOW". Therefore, I can't even start the 3d print.
Also, I have PVA as a ...
Also, I have PVA as a ...