Search found 3 matches
- Tue Jan 19, 2021 5:11 pm
- Forum: Geeetech A30 Series
- Topic: BLTouch on A30T
- Replies: 2
- Views: 3883
BLTouch on A30T
Hello, I installed a BLTouch on my A30T (firmware v1.01.02, hardware v1.03). Wiring according to the Geeetech diagram (3-wire connector: brown wire at the top, red in the middle and orange at the bottom on the left connector. 2-wire connector: Black at the top and white at the bottom on the right ...
- Tue Dec 15, 2020 11:43 pm
- Forum: Geeetech A30 Series
- Topic: A30T Extruder Calibration
- Replies: 4
- Views: 7612
Re: A30T Extruder Calibration
I managed to do this with smartto motor tool. 
- Tue Dec 15, 2020 5:44 pm
- Forum: Geeetech A30 Series
- Topic: A30T Extruder Calibration
- Replies: 4
- Views: 7612
A30T Extruder Calibration
Hello,
I wanted to check my extruder. I connected the printer via usb. I am using repetier 2.1.6. I made a mark at 100 and 120mm on the filament. In manual control, I sent the M83 command to switch the extruder to relative mode. Then sent the command G1 E100 F100, I had to send it four times before ...
I wanted to check my extruder. I connected the printer via usb. I am using repetier 2.1.6. I made a mark at 100 and 120mm on the filament. In manual control, I sent the M83 command to switch the extruder to relative mode. Then sent the command G1 E100 F100, I had to send it four times before ...