Videos of MK8 Extruder assembly

Post Reply
zhangxueyou
Posts: 1405
Joined: Fri Feb 06, 2015 1:33 pm

Videos of MK8 Extruder assembly

Post by zhangxueyou »

In this video, you will see how to tear the mk8 extruder down, and how to replace new extruder kits.
https://www.youtube.com/watch?v=aPvVUZQnOMM
How to replace extruder thermistor:
https://www.youtube.com/watch?v=FR0n2FHrjmc
How to replace nozzle:
https://www.youtube.com/watch?v=t2tUxrZDi8o
How to level dual extruder:
https://www.youtube.com/watch?v=XGpcueI ... e=youtu.be
mava70
Posts: 20
Joined: Sun Nov 01, 2015 8:20 am

Re: Videos of MK8 Extruder assembly

Post by mava70 »

hello the heater and the thermistor move inside the hole out and in, can be fixed someway?
Mark
Posts: 1553
Joined: Thu Aug 06, 2015 9:19 am

Re: Videos of MK8 Extruder assembly

Post by Mark »

there's a setscrew for the heating cartridge, did you see that? and you can use a cable tie to tie them up.
mava70
Posts: 20
Joined: Sun Nov 01, 2015 8:20 am

Re: Videos of MK8 Extruder assembly

Post by mava70 »

Hello there is a small hex screw next to the hole in the back but I tryed to turn clockwise the screw go inside the hole a lot but don't fix. Should I turn a lot more?
Mark
Posts: 1553
Joined: Thu Aug 06, 2015 9:19 am

Re: Videos of MK8 Extruder assembly

Post by Mark »

I remember the setscrew is side of the heating block not in the back, maybe you need to remove the sponge thing to check it, and you can screw it a little tight.
Attachments
QQ截图20151125155347.jpg
QQ截图20151125155347.jpg (67.11 KiB) Viewed 38900 times
calabrovarijo
Posts: 4
Joined: Sun Jun 16, 2019 9:31 pm

Re: Videos of MK8 Extruder assembly

Post by calabrovarijo »

zhangxueyou wrote: Fri May 29, 2015 10:35 am In this video, you will see how to tear the mk8 extruder down, Audacity Find My iPhone Origin and how to replace new extruder kits.
https://www.youtube.com/watch?v=aPvVUZQnOMM
How to replace extruder thermistor:
https://www.youtube.com/watch?v=FR0n2FHrjmc
How to replace nozzle:
https://www.youtube.com/watch?v=t2tUxrZDi8o
How to level dual extruder:
https://www.youtube.com/watch?v=XGpcueI ... e=youtu.be
is side of the heating block not in the back, maybe you need to remove the sponge thing to check it, and you can screw it a little tight.
randyhavens
Posts: 1
Joined: Mon Jul 04, 2022 2:50 pm

Re: Videos of MK8 Extruder assembly

Post by randyhavens »

You can try removing the sponge thing to check it, and screw it a little tight.
gmail sign up
Post Reply