Problems with starting the controller board.
Problems with starting the controller board.
I tried using the smartto firmware tool and the st micro tool i can not get any bin files to work. Just a gtm32 hex file but it only allows me to connect but doesnt control anything so it might be for one of the other cards. Since the board has an sd card slot it seems like it would have come with an sd card with firmware on it but nope. I have the m201 with the gtm32c pro vb. The saler didnt include the lcd cable so i cant even see whats going on. Could that be a reason its not working
Re: Problems with starting the controller board.
Hello Ken.
I have a proposition for you.
Please read the forum below:
1.
2.
3.
4.
These posts contain basic information about what you might want to achieve.
The first link is the most important. Take extra attention by reading paragraph 4 of point 6.
I have a proposition for you.
Please read the forum below:
1.
2.
3.
4.
These posts contain basic information about what you might want to achieve.
The first link is the most important. Take extra attention by reading paragraph 4 of point 6.
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.