New A10 with mylar, what to do with the sticker

[BucksDanny]

Hello, I just purchased my first Geeetech A10 printer. It is delivered with an aluminium hotbed and a mylar sticker.

Hotbed with blueish sticker and mylar sticker

1.jpg (157.13 KiB) Viewed 14988 times

Unfortunately there are no instructions how to install it. Just sticking it on seems pretty straightforward, but what do I need to do with the blueish sticker that is currently stuck on the hotbed? I suspect it to be a protective sticker for transportation but I am not 100% sure if I should remove it.
Somebody can help me out?

[William]

Hi, You need to glue the mylar to the aluminum substrate,
Remove the protective film if it is on the aluminum substrate
Then stick the Mylar to the aluminum substrate.