mix menu not translated, always in chinese
no screws were tightened properly when I unpacked it.
I had to replace a lot of poor quality screws.
3D touch dont give 2X same value. Impossible first layer.
bed curved, impossible level.
Bad PID value, temperature unstable.
After flash firmware A30T from A tech geeetech, fanduct fan always on, impossible to stop !
i have loose 500euro !
i call paypal monday to block my money pending geeetech send all parts replacement.
And the tech say always "my friend" i m not your friend, i have buy a printer for my company and not work ! i m not a beginner, i have many many many printer in my home and my company !
i need a new mainboard, i need a fixed firmware, i need a working 3D touch, i need a good bed not curved !
ITS OK NOW ?
YOU UNDERSTAND "MY FRIEND" ?
DONT BUY !!!! WAIT !!!
