Best MeCreator 2 Mods

[JohnQuix]

Hey all,

I was wondering what mods everyone uses on their MeCreator 2.

I personally have added Active Cooling and Borosilicate Glass with a PEI sheet on top. These make the MeCreator 2 an unbelievably good printer. In fact I can't believe I printed for so long without the Active Cooling.

I have a 3DTouch that I want to install but not sure how to make it work.

What have you all done to improve your printers?

[Kite79]

hi, have you find how connect 3d touch???
Tnk for any replay :D

[orenjikuma]

I am looking for a 3d touch guide too, Ive seen some implementations but there were no guides on how to get it done :<

[Gingko]

You can probably check out this wiki :) :
http://www.geeetech.com/wiki/index.php/ ... ing_Sensor

[orenjikuma]

[quote=Gingko post_id=84073 time=1525664224 user_id=65378]
You can probably check out this wiki :) :
http://www.geeetech.com/wiki/index.php/ ... ing_Sensor
[/quote]

Unfortunately the gt2560 revB have far less pins available than RevA, making it difficult to implement.

[DaydreamVoid]

You can probably check out this wiki :
http://www.geeetech.com/wiki/index.php/ ... ng_Sensor/DQFanSurvey

This is really amazing. Great information about blog.