Filament do not stick on the Super plate
Filament do not stick on the Super plate
Just fitted new Super plate, but work is coming off from the plate, do not stick. Coming of in the middle of work. Do I need to use glue or something else?
Re: Filament do not stick on the Super plate
I just received my Super Plate in the mail today, and immediately fitted it to my A30T.
Although I was getting perfect ABS prints using the original mylar platform, as soon as I tried my first print on the Super Plate, it was instant disaster as the first layer didn't adhere at all, with the same slicer parameters.
I found an extremely simple kludge was to reduce the z-axis clearance by 0.015mm using the auto-leveler.
I normally print the first layer at 0.3mm. Changing my z-axis offset from -1.85mm to -2mm seems to have done the trick. I can now get a perfect ABS print done again.
Although I was getting perfect ABS prints using the original mylar platform, as soon as I tried my first print on the Super Plate, it was instant disaster as the first layer didn't adhere at all, with the same slicer parameters.
I found an extremely simple kludge was to reduce the z-axis clearance by 0.015mm using the auto-leveler.
I normally print the first layer at 0.3mm. Changing my z-axis offset from -1.85mm to -2mm seems to have done the trick. I can now get a perfect ABS print done again.