A30t each extruders calibration

[nickscorpion]

Are you talking about the A30T..
Because I don't think it works for it..
I have done that for all my other printers..
But for this there is not custom firmware yet..
Yes.. there is marlin ready for it.. but you can't use it because there is not the right firmware for the screen...
What I'm not understanding is if everybody here are talking about the A30T... Because on mine if I change the e steps value it only changes the first extruder that's it..

The screen changes for the first, but then, when measuring, all extruders are squeezed out relative to the changed parameter. I have so.

[kokko3d]

Are you talking about the A30T..
Because I don't think it works for it..
I have done that for all my other printers..
But for this there is not custom firmware yet..
Yes.. there is marlin ready for it.. but you can't use it because there is not the right firmware for the screen...
What I'm not understanding is if everybody here are talking about the A30T... Because on mine if I change the e steps value it only changes the first extruder that's it..

The screen changes for the first, but then, when measuring, all extruders are squeezed out relative to the changed parameter. I have so.

This is the problem for me... When I change on the screen and then I measure the first is ok and the other 2 are almost 3 times longer... So.. must be something wrong...

[nickscorpion]

This is the problem for me... When I change on the screen and then I measure the first is ok and the other 2 are almost 3 times longer... So.. must be something wrong...

What firmware do you have? I have A30T-V1.02.03. I have a control board SMARTTO

[kibanjain]

my problem is different....
i have changed all 3 the extruder and i want a new e step value for all 3 the extruders... but when i change it it changes only extruder 0
the other 2 extruders are still with the old value.. so they are not working with my new extruders...
https://showbox.tools/