Problems with new 3D Printer

[rawdy1992]

Hi,

I Buy this printer: http://www.ebay.com/itm/JIETAI-Delta-Ro ... 4182bbdf69

I assemble and configure with Repetier Host. The radius of 99 mm and height of 400 mm .When pressed home all rises to endstops, but when sending XYZ to 0 the printer does nothing. To check, try print 10mm cube and starts printing from above, Z is the only that move down.

what I can do with this problem ???????????

[koko]

please makesure "printer settings">"printer shape">"printer type" is "Rostock printer" and "Home X,Home Y,Home Z" is MAX with Repetier Host.if you use slic3r ,Please amend the print center of 0, 0.