Z-Axis will not move

[bmd]

Hello,

I own the Prusa i3 Acrylic kit: http://www.geeetech.com/acrylic-geeetec ... p-917.html

I am having trouble with the z axis. When using repetier, it does not rotate, it also doesn't work when I use the lcd. Homing the x and y work perfectly but not the z. It only buzzes. I tried adjusting the driver motor to a higher voltage but it doesn't help. Also, for my x and y, it appears that it doesn't move exactly 1mm (probably 3mm) every time I click, and when I press 10mm or more, it will only move a few mm.

Does anyone know of a solution? I can upload a video of my printer if it helps.

Thank you

[zhangxueyou]

Maybe you did not adjust the substep correctly. Please adjust it according to the tutorial

[bmd]

What do you mean by substep? Sorry I don't know that one.

[zhangxueyou]

You can refer to our wiki page: http://www.geeetech.com/wiki/index.php/Sanguinololu . You can find how to adjust step at chapter 4.

[bmd]

I do not understand the wiki. I dont see where it shows where I can adjust anything. Can I show you a picture of my board?

[bmd]

I don't see where it says I can adjust my step in chapter 4. Can I send you a picture of my board?

[wenganxiang]

3 jumper caps should be plugged under each A4988 module. And there should be a jumper cap above the second A4988.

QQ截图20150212093031_副本.png (622.53 KiB) Viewed 14511 times

[bmd]

Oh I never received these in my kit. Where do I buy these caps?

[zhangxueyou]

That's impossible. They are packed with A4988 or other parts. Please check again carefully.

QQ图片20150212175041.jpg (4.34 KiB) Viewed 14503 times