Sanguinololu Rev 1.3a Firmware

[my900ss]

I have the Unassembled-Full Acrylic Quality High Precision Prusa Mendel I3.
Sanguinololu Rev 1.3a
Nozzle 0.3mm
PTFE tube size 1.75mm


I need the firmware(ZIP.files) to upload it to my controller with arduino.

Thanks,

Troy

[rita]

hello troy, please leave your e-mail address

[my900ss]

Ms. Rita,
If you would be so kind as to email it to me I would be grateful.

Troy

[darraughbj]

Ms. Rita,
I am in need of this firmware as well, would you be so kind as to send me a copy? darraughbj@gmail.com

Bart

[rita]

firmware sended, please check your mail

[my900ss]

Rita,
I do not see an e-mail from you yet?

[rita]

Hello, Troy, please check again

[my900ss]

Rita,
I received the FW thank you.

Troy

[darraughbj]

Thank you, burned in perfectly.

[my900ss]

Pardon me if I am a little frustrated, but I am unable to load the FW. There are large gaps in your FW procedure, I cannot resolve or even get close to resolving the FW issue on this Sanguinololu board. I will need either clear and concise directions on how to install the FW I was provided or a new board with the FW installed.

Regards,

Troy