sanguino does not show in Arduino

[szeiger]

How do we get the sanguino board to show up in Arduino/tools/board? the directions in one place say to move "sanguino" into arduino/hardware, but where do we get that file from?

[zhangxueyou]

You can refer to this page:
http://www.geeetech.com/wiki/index.php/ ... _To_set_up
You can find the "sanguino" folder under "hard ware" in the installation directory of Arduino IDE.

[szeiger]

the sanguino file does not show up in the arduino directory. Where can I download it from?

[szeiger]

Ok, that link helped me get the right Repetier Host software. I apoligize for not reading the instructions carefully enough. Now I just need to get the sanguino file into Arduino to upload the firmware file to the machine.
Where do I find the sanguino file?

[szeiger]

resolved

[zhangxueyou]

Hi, you can see the first post at this page:
http://www.geeetech.com/forum/viewtopic ... 14&t=16097
There is download link for Sanguinololu.