PTFE Tube for 1.75 and mk8

Post Reply
animetown9
Posts: 24
Joined: Thu Feb 26, 2015 4:38 am

PTFE Tube for 1.75 and mk8

Post by animetown9 »

Hi

My nozzle was clog for Mk8. So I took it apart and clean it.
1.75mm nozzle 0.3mm.

Anyway, a piece of PTFE Tube for 1.75 fell off.
I didn't see where it come from. Do you have a picture of Pteee tube 1.75mm where I should put back into mk8 extruder.

Thank
zhangxueyou
Posts: 1405
Joined: Fri Feb 06, 2015 1:33 pm

Re: PTFE Tube for 1.75 and mk8

Post by zhangxueyou »

Is this picture clear for you?
QQ截图20150403104223.png
QQ截图20150403104223.png (372.24 KiB) Viewed 5021 times
Post Reply