Auto leveling on delta G2 :erratic moves

[th7511]

HI,

I go through the set up procedure and everything was fine until G29 auto leveling

i do a G28 command , fine

then when i ask a G29 auto level
head go down (half height) then start to move in 16 different location
but going solely up between each point:
going to a point , move up, another point, move up....

then after that, moves to a strange position, near the hot bed in a corner (?!)
until i have to do an emergency stop to avoid damaging something

any idea?

thanks

note: on the documentation, it's not clear what to do with some red values:
// Travel limits after homing
365 #define X_MAX_POS DELTA_PRINTABLE_RADIUS
366 #define X_MIN_POS -DELTA_PRINTABLE_RADIUS
367 #define Y_MAX_POS DELTA_PRINTABLE_RADIUS
368 #define Y_MIN_POS -DELTA_PRINTABLE_RADIUS
369 #define Z_MAX_POS MANUAL_Z_HOME_POS
370 #define Z_MIN_POS 0

398 #define Z_RAISE_BEFORE_PROBING 100

[bruno99]

I have the same problem on a delta G2S

[Sherry]

could you upload the video to youtube,and leave the link for me.

[darkikal]

is the same too by here and also when i send the comand M119 nothing happens, home is working fine but the rest all erratic moves a solution please it was hard to arrive at this pointXD

[Mark]

Could you give me some more details ? A vedio can be good.

[darkikal]

vedio? the thing is i need to know how to adjust the parameters and the probing points but when i take the spider manually to get the coordinates they dont appear on the ma nual control of repetier

[Mark]

It's your machine successfully connected to the repetier?

[darkikal]

okey the big problem was the swicht i have reversed it on the marlin now there is only the thing of the probing points i dont understand it in the guide....

[Mark]

the swicht i have reversed it on the marlin

Can you tell me in detail ? I'd like to know how and why ,tks!

[darkikal]

i have seent you the reply by messagexd