Acrylic Prusa I3 build instruction(8mm)

nagromlt · Post by **nagromlt** » Mon Apr 27, 2015 7:24 am

For the instructions on mounting the Y-motor on the Geeetechwiki page, it lists M3x16 screws to mount the motor plate but the image/picture shows M3x20 screws...

Which is the correct screw to use

zhangxueyou · Post by **zhangxueyou** » Mon Apr 27, 2015 4:53 pm

16 is correct.

Warfey · Post by **Warfey** » Mon Aug 03, 2015 11:37 am

Im stuck at attaching the Y-Motor. As the instructions state, I pulled the length 16 screws to use, but they are simply not long enough. Unless I was super unlucky and the little baggy with the screws in them were mislabled. I checked and the M3x20 screws fit perfectly.

nagromlt · Post by **nagromlt** » Tue Aug 04, 2015 6:55 am

Yeah I ended up using the 16 screws.

Geeetech

Acrylic Prusa I3 build instruction(8mm)

Acrylic Prusa I3 build instruction(8mm)

Re: Acrylic Prusa I3 build instruction(8mm)

Re: Acrylic Prusa I3 build instruction(8mm)

Re: Acrylic Prusa I3 build instruction(8mm)