Filament doesn't go through correctly...sometimes

Mark
Posts: 1553
Joined: Thu Aug 06, 2015 9:19 am

Re: Filament doesn't go through correctly...sometimes

Post by Mark »

Is your hotend temperature too high that caused the clog? Maybe it is not well cooled down.
Robo Techy
Posts: 20
Joined: Wed Jul 01, 2015 12:03 pm

Re: Filament doesn't go through correctly...sometimes

Post by Robo Techy »

Yes, it might be the heater setting was too high (250C), however, as in my other posts, the real issue is the lack of a bevel on the throat and the gear is too large for 3mm and makes the filament bend to get through.
Post Reply