delta g2 printing problem

[darkikal]

afters a huracan of troubles it start printing, but again a new problem, i take a mini bomb like test because its almost a ball the base is almost perfect but when star going up it begin to put more platic in a side and extend the base( but there is base in this part) and finally i get an amorfical piece of plastic the calibration and all in the guide is succesful is pla the bed at 95 and extruder 190.........

[Mark]

I use pla ,and my bed temp is 60-70, extruder is 190-230, you can try it .