Retractation settings ?

Post Reply
mediaklan
Posts: 63
Joined: Wed Mar 04, 2015 4:00 pm

Retractation settings ?

Post by mediaklan »

Hi everyone !
Here's a question ^^.
I'm using MatterControl for quite some time, and I love the software. I played with some settings but now I can't remember what I'm supposed to put in this setting, considering my printer, a Geeetech Prusa i3 Pro B :
"Retraction - Lenght on move :
The amount that the filament will be reversed after each qualifying non-printing move."

I'm supposed to put something here in mm ... The closest setting I could find in Slic3r made me guess it could be 2mm.
Am I right ?
Thank you in advance !
Mark
Posts: 1553
Joined: Thu Aug 06, 2015 9:19 am

Re: Retractation settings ?

Post by Mark »

Yes, it is the same setting.
mediaklan
Posts: 63
Joined: Wed Mar 04, 2015 4:00 pm

Re: Retractation settings ?

Post by mediaklan »

Thank you ! I will give it a try then !
Post Reply