HELLO MY NAME IS mARCO i am french
config sanguinololu 1.3 lcd panololu arduino 10.00 windows 10
I HAVE THIS MESSAGE OF ERROR SOLUTION WOULD YOU
In file included from /Marlin.h:22,
from BlinkM.cpp:5:
Configuration.h:48: error: expected unqualified-id before numeric constant
ERROR
Re: ERROR
Have you select the correct board type in your firmware?
If so, this might probably caused by the arduino version, you can try to use another version, but don't use the latest one, it has lots of problems.
here is the link for the arduino1.0.1 I use:
http://www.geeetech.com/wiki/index.php/ ... _Resources
and you can refer to the link here to install the firmware:
http://www.geeetech.com/forum/viewtopic ... 20&t=16433
If so, this might probably caused by the arduino version, you can try to use another version, but don't use the latest one, it has lots of problems.
here is the link for the arduino1.0.1 I use:
http://www.geeetech.com/wiki/index.php/ ... _Resources
and you can refer to the link here to install the firmware:
http://www.geeetech.com/forum/viewtopic ... 20&t=16433