Board problems

[erniehatt]

I just received a GT2560 board, and after connecting it all up, I find a few problems with it, mainly the motors. They are only working one way, sort of. I have run out of ideas, The printer was working fine with the Ramps 1.4 and arduino mega 2560, so I know the motors and drivers are ok. Maybe there are some software settings I need.

[Mark]

did you home the printer? If you didn't do that then all the axis will only go towards one way.

[erniehatt]

did you home the printer? If you didn't do that then all the axis will only go towards one way.

Thanks Mark, but not quite sure what you mean by homing the printer, I am pretty new to this..

Ernie

[Mark]

when you use the repetier host, click the "house"button then all the axis will home to the endstop position.

QQ截图20160113174217.jpg (203.09 KiB) Viewed 6020 times