Mini G2Pro Firmware Update etc

[kyle59]

Wow am I feeling a bit dumb

I have finished the build of my Mini G2Pro and have connected successfully to the PC. I have downloaded the newest firmware update and installed Arduino on the PC. Now I have trouble working out what I need to alter in the config settings in order to upload to the printer. Seems everything is right, but it wont pass through the verify part and therefore cannot upload to the printer.

Any advice would be very welcome.

I have printed out the instructions from the Wiki, but it seems to have not helped me in this case.

Maybe the part I am short on is where the Wiki says to "Find the Value you need to compile according to your printer" I am not seeing where I need to alter this??

Thanks guys.

Kyle

[Mark]

what's the error you got? and suggest you use the arduino1.0.1, it's more stable and useful.
Also the settings to alter, did you get the quicker starter manual? it will tell you how and where to do this, you can download it in the product page.

[kyle59]

Thanks again mark.
I downloaded Arduino 1.0.1 and things were much better. I also had the issue of putting the hotend thermistor in the wrong plug, but fixed that. All fixed up, firmware updated and calibration done. Now just to research the next step which is loading the plastic in and starting my first print. I thought I had it all right, but the LCD displayed Heating, yet nothing heated up at all, so a bit more exploring and researching to find that issue.

Kyle

[Mark]

I think you can check this link here:
http://www.geeetech.com/forum/viewtopic ... 19&t=17039