When i was building my Geeetech Prusa I3 M201. I also got 5 small heat sinks. And i don't know where i have to place them. And are the blue stickers there to glue the heatsinks?
I also got a "Ejector pin" and i don't what i can/should do with it.
Kind regards,
Barry
Geeetech Prusa I3 M201, heat sink and Ejector pin
Re: Geeetech Prusa I3 M201, heat sink and Ejector pin
yes you're right, use the glue stickers to stick the heatsink on the drivers to help them cool down. And the ejector pin is used to clean the hotend when it's clogged, check out this link:
http://www.geeetech.com/forum/viewtopic ... 19&t=17097
http://www.geeetech.com/forum/viewtopic ... 19&t=17097