HELP REQUIRED

Post Reply
hooked
Posts: 17
Joined: Fri Dec 11, 2015 7:41 am

HELP REQUIRED

Post by hooked »

Hi,

I had to replace the computer that was connected to my G2 printer. I have installed Repetier Host on the new computer but can't get the printer working.

Repetier host does connect but I get the following message. "No Start Signal detected - forcing start"

Do I have to reload the printer firmware. I'm assuming it is still resident on the printer EEPROM.

Any suggestions would be greatly appreciated.

THANKS

Daryl
hooked
Posts: 17
Joined: Fri Dec 11, 2015 7:41 am

Re: HELP REQUIRED

Post by hooked »

Disregard my post. I found the problem. I had not installed the fdi driver.

Cheers

Daryl
User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: HELP REQUIRED

Post by William »

hooked wrote:Disregard my post. I found the problem. I had not installed the fdi driver.

Cheers

Daryl
:roll:
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Post Reply