Hello everyone, I'm new here. Just get my new mecreator2, I'm still testing and trying to print ABS, PLA works very well.
My question is: Is normal that the fan extruder are always working, and alwaus in the maximum?
Thank you all.
About the fan extruder, always on?
Re: About the fan extruder, always on?
It's quite normal, the fans will be always on until you power off the printer.
Re: About the fan extruder, always on?
Thanks, I stay relaxed. 
Re: About the fan extruder, always on?
It would be useful to have the ability to change the fan speed on the first layers.
Is this possible with Mecreator?
Is this possible with Mecreator?
Re: About the fan extruder, always on?
Hi,SirHaugen wrote:It would be useful to have the ability to change the fan speed on the first layers.
Is this possible with Mecreator?
Sorry to tell you it can't.
Regards
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: About the fan extruder, always on?
Really you can do that. The board that control the fan have two connectors, one of them are always on, the other is located at the side of this, it's name is FAN_PWM, with this you can control the fan speed with manual control, and when you are printing also is controlled. I don't know if this connector was designed for this, but is useful for that porpuse. Use with caution 
.
Bye
. Bye