Y axis problem

Anehall · Post by **Anehall** » Tue Jul 26, 2016 3:38 am

Hi!

When i hit home on Y axis the bed goes in the wrong direction but only like 1mm, hit home again and it moves 1mm in the wrong direction again and so on. Cant get the bed moving towards the end stop at all...

Tried changing the cables on the end stop but then it says end stop hit all the time...

Thanks

Post by **William** » Tue Jul 26, 2016 11:22 am

Anehall wrote:Hi!

When i hit home on Y axis the bed goes in the wrong direction but only like 1mm, hit home again and it moves 1mm in the wrong direction again and so on. Cant get the bed moving towards the end stop at all...

Tried changing the cables on the end stop but then it says end stop hit all the time...

Thanks

Hi,
I guess this would be helpful:
http://www.geeetech.com/forum/viewtopic ... 17&t=17037

Geeetech

Y axis problem

Y axis problem

Re: Y axis problem