Y axis shift problem

Brintros · Post by **Brintros** » Tue Oct 11, 2016 7:22 pm

Hello friend im new here i have buildt a geeetech prusa i3 x that print pretty good but not this night i have a little y axis shift as you can see on the picture the shift was just 1 layer and 5 hours after the print start ??! What is the problem ?

Post by **William** » Wed Oct 12, 2016 1:53 pm

1.Make sure your print speed is not too fast.
2.Check if the belt on Y axis is too loose or too too tight.
3.Check if the bearing on the Y belt is broken.

Post by **William** » Wed Oct 12, 2016 1:57 pm

BTW,didn't find the picture you mentioned...

Brintros · Post by **Brintros** » Wed Oct 12, 2016 6:14 pm

Hello here is the picture

my belt is ok and i have a fan on the gt2560 board

Post by **William** » Sat Oct 15, 2016 4:33 pm

You can try increasing the driver voltage of Y axis A4988 a little,and spread some lubricating oil to the Y axis driver wheel and the linear bearings on Y axis.

Geeetech

Y axis shift problem

Y axis shift problem

Re: Y axis shift problem

Re: Y axis shift problem

Re: Y axis shift problem

Re: Y axis shift problem