Extruder filament problem

Post Reply
Svampen
Posts: 3
Joined: Fri Feb 17, 2017 12:02 pm

Extruder filament problem

Post by Svampen »

Hey guys i have a problem with my geeetech i3 Pro b when im trying to make it pull out 100mm filament i only get about 25mm and i have tryet to turn up the estep but that didn't helped i have also tryet difrent filaments and heats but it just dont want to pull more then about 25-30mm and thats not even close to be enough
bang
Posts: 402
Joined: Wed Dec 28, 2016 2:12 pm

Re: Extruder filament problem

Post by bang »

Pulling out 100mm for the extruder once is too fast for it.
Maybe you can try pulling it out 10mm everytime to take a look or just print one model to see.
Svampen
Posts: 3
Joined: Fri Feb 17, 2017 12:02 pm

Re: Extruder filament problem

Post by Svampen »

I cant even print a model cause its not pulling enough filament out its just looks like support material
bang
Posts: 402
Joined: Wed Dec 28, 2016 2:12 pm

Re: Extruder filament problem

Post by bang »

The same problem?
viewtopic.php?f=19&t=18507
Svampen
Posts: 3
Joined: Fri Feb 17, 2017 12:02 pm

Re: Extruder filament problem

Post by Svampen »

naaah i dont think thats the problem i just tryet it and i didnt make any different
bang
Posts: 402
Joined: Wed Dec 28, 2016 2:12 pm

Re: Extruder filament problem

Post by bang »

So what did you have in mind?
Post Reply