Y movement changes during print
Y movement changes during print
My prints start good but after a short time the Y motor clicks and misses steps meaning that the y direction is about halved. The stepper functions well at the start but after about a minute jumps into this click and missing step routine. Can any one help?
Re: Y movement changes during print
I think you can swap the Y axis and X axis motor driver board A4988
Then you can test it.You will find the issue is A4988 or not
Then you can test it.You will find the issue is A4988 or not
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: Y movement changes during print
You can increase the controller current.