hello, I installed correctly the sensor but the tilt tends to hang and activated the alarm (red flashing)
It hangs down, I try to go up or down the screw (magnet), it works but from time to time it still blocks, do you have any tips or a link to correctly configure the sensor screw please ?
thank you
Level bed sensor on pro b need help
-
halleuxgeoffrey@msn.com
- Posts: 2
- Joined: Sat Nov 12, 2016 12:54 pm
Re: Level bed sensor on pro b need help
I think you should refer to your 3dtouch user manual at first?
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-
halleuxgeoffrey@msn.com
- Posts: 2
- Joined: Sat Nov 12, 2016 12:54 pm
Re: Level bed sensor on pro b need help
Nothing about this adjustement with the magnet screw on top of the sensor anywhere.
With chance, it happen not too much, but when arrive, i must enter the gcode for stop the alarm and adjust the screw, is it like the screw move itself when extrudor viber.
With chance, it happen not too much, but when arrive, i must enter the gcode for stop the alarm and adjust the screw, is it like the screw move itself when extrudor viber.