I haven't measured what the offsets are, but it seems that this is something that should be corrected in the next firmware. The hotend reads close enough, but also appears to be off somewhat on the cold/base temperature.Bed Temperature Offset
Bed Temperature Offset
So i'm fairly sure the bed temperature scale is off by some factor. When the bed heats, it heats to whatever "number" you set it to. But when the bed cools to room temperature, it cools to 0 degrees C... and its definitely not that cold in my house. I haven't measured what the offsets are, but it seems that this is something that should be corrected in the next firmware. The hotend reads close enough, but also appears to be off somewhat on the cold/base temperature.
I haven't measured what the offsets are, but it seems that this is something that should be corrected in the next firmware. The hotend reads close enough, but also appears to be off somewhat on the cold/base temperature.
Re: Bed Temperature Offset
Hi.
The manufacturer has adopted a scenario where it is known that the heating is switched off.
The manufacturer has adopted a scenario where it is known that the heating is switched off.
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.