the hot-end of my extruder mk8 is no longer able to extrude properly
the hot-end of my extruder mk8 is no longer able to extrude properly
I have a problem ... the hot-end of my extruder mk8 is no longer able to extrude properly, I continue problems from hitch, which according to what I have tried do not come from the nozzle blocked but from the throat ... that is, inside the screw where the thread inside the heater, it does not slip any better, what could it be, what should I do? Can you clean? If so how? Or do I have to change it? Thank you
Re: the hot-end of my extruder mk8 is no longer able to extrude properly
Hello.
You've probably got a blockage in this part.
To remove it you will have to disassemble everything.
You've probably got a blockage in this part.
To remove it you will have to disassemble everything.
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.