After assembly i switch the PSU to 230V (i live in Germany) and connect it. Short flames and smoke came out of the PSU.
After disconnect the Printer, i try again, but the result was the same.
Sorry for my bad english
New A30 3d Printer - PSU exploded when plugged in
New A30 3d Printer - PSU exploded when plugged in
Today im buying a Geeetech A30 3D Printer "used" in a original, closed package.
After assembly i switch the PSU to 230V (i live in Germany) and connect it. Short flames and smoke came out of the PSU.
After disconnect the Printer, i try again, but the result was the same.
Sorry for my bad english
After assembly i switch the PSU to 230V (i live in Germany) and connect it. Short flames and smoke came out of the PSU.
After disconnect the Printer, i try again, but the result was the same.
Sorry for my bad english
Re: New A30 3d Printer - PSU exploded when plugged in
Hello.
You told us what had happened to you. But you didn't ask a question.
You told us what had happened to you. But you didn't ask a question.
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Re: New A30 3d Printer - PSU exploded when plugged in
[/quote]
Is there any solution? Is the same thing happend to everyone here?
Ups... what can i do?_kaktus_ wrote: Fri Nov 09, 2018 3:02 am Hello.
You told us what had happened to you. But you didn't ask a question.
Is there any solution? Is the same thing happend to everyone here?
Re: New A30 3d Printer - PSU exploded when plugged in
This is not a daily situation.
There is an irregularity somewhere.
You can try to disconnect the power supply load and run it.
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.