Im using astroprint.
Does anyone have some good settings for astroprint?
Im quite sure they are using slic3r.
Also I always having a hard time removing the support material. any suggestions for settings here?
Share your A10 slic3r/astroprint settings ;-)
-
WhippingBoy
- Posts: 27
- Joined: Sun Nov 11, 2018 4:25 am
Re: Share your A10 slic3r/astroprint settings ;-)
You can refer to it:
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: Share your A10 slic3r/astroprint settings ;-)
Set the support to "Lines,5%"
-Keep your mind and try to test it.
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-
WhippingBoy
- Posts: 27
- Joined: Sun Nov 11, 2018 4:25 am
Re: Share your A10 slic3r/astroprint settings ;-)
Dear William.
I cant find support lines in the gui?
https://manual.slic3r.org/expert-mode/p ... t-material
I cant find support lines in the gui?
https://manual.slic3r.org/expert-mode/p ... t-material