My printer does pauses during my print

[Briciou62500]

Hi,

I have a problem, my Geeetech a30 does pauses during my print.
I do not know where the problem comes from, do you have an idea?

Thank you,

[jasonc]

i had same problem. just updated firmware with one attached. no problem now at all

[Briciou62500]

Thanks, I go try to upgrade my firmware tomorrow.

[anrkii]

If the firmware doesnt help, try using a different SD card, My pausing problems were caused by an SD that the printer didnt like.

[Briciou62500]

Hi, I did not have time for try your solutions. OK, thank you very much for your solution.

[Briciou62500]

Hi,
I have upgrade my A30, I have change my SD card.

I saw by heating the nozzle to 210 ° C to test to print a temperature tower, my printer these paused, the temperature was 200 ° C and not 210 ° C. I do not see where it can come from, would you have an idea please? Is it possible that he is posing for the wrong temperature? Thank you all