screen calibration error
screen calibration error
Hi all, I'm new to this forum, I bought an A30 and I suffered a problem, after finishing the mount it, I turn it on and appear the three icons (Control, Printing, Setting). By clicking on any icon the screen goes into the touchscreen calibration mode (all blue screen with the cross). By clicking on the cross to perform the calibration, the error message "screen calibration failed, please try again" always comes out. Any operation I do comes out always the same error message. I'm stuck in this situation. Please if anyone can give me a tip of how to get out of it. Thanks and a greeting.
Re: screen calibration error
That's just a suspicion now. Is it possible that the LCD display was screwed in too tight?
You can open the Control Box below with 5 screws. Unscrew the power supply with the 4 side screws. Then loosen a little bit the 4 screws fixing the LCD display. Now test again.
You can open the Control Box below with 5 screws. Unscrew the power supply with the 4 side screws. Then loosen a little bit the 4 screws fixing the LCD display. Now test again.