print quality

[Murphyprecht]

Hi folks, I built my I3 last week and made some prints with dubious quality. I'm happy to do some tinkering but as this is my first printer, I'm unsure where to begin. Any advice would be welcome. I think the box at the back of the cabin shows signs of z wobble, what do you guys think?

20190120_113657-2268x3024.jpg (312.54 KiB) Viewed 5651 times

20190120_113643-2268x3024.jpg (232.65 KiB) Viewed 5651 times

[Murphyprecht]

Ok, I changed my slicer to Cura and slowed the print to 40mm. Absolutely delighted.

20190120_171846-2268x3024.jpg (261.72 KiB) Viewed 5642 times

20190120_171831-2268x3024.jpg (303.44 KiB) Viewed 5642 times

[jzero42]

I think you should add a parts cooler fan and you can print the z-wobble fix (search on thingiverse), though I don't think that helped me that largely.
My benchy, same printer:

bench2.jpg (106.56 KiB) Viewed 5612 times

benc.jpg (138.54 KiB) Viewed 5612 times

[Murphyprecht]

Yeah I've got the toroidal cooler on now but need to find the correct plug for the board lol