Hello,
My i3 Pro C has Firmware V1.0.04. What is the difference to V1.0.04_01?
Probably only change from treaded rods to trapezoidal threaded rods?
Moritz
New Firmware I3proC_G02_V1.0.04_01
Re: New Firmware I3proC_G02_V1.0.04_01
I've checked it.
It seems the same version firmware.
It seems the same version firmware.
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: New Firmware I3proC_G02_V1.0.04_01
Dear Friends
It saddens me that I have been trying to get my GEEETECH i3C per operation in vain for two months. The problem is that no one can help me with the question WHY?
Is it the hardware or the software? Did I set wrong parameters somewhere, etc.
I would like to read a working GCODE file to see if the hardware works.
Handically, everything goes.
Maybe someone can help me?
best regards
Detlef
It saddens me that I have been trying to get my GEEETECH i3C per operation in vain for two months. The problem is that no one can help me with the question WHY?
Is it the hardware or the software? Did I set wrong parameters somewhere, etc.
I would like to read a working GCODE file to see if the hardware works.
Handically, everything goes.
Maybe someone can help me?
best regards
Detlef
Re: New Firmware I3proC_G02_V1.0.04_01
Here are some gcodes and my Slic3r Config.
- Attachments
-
- 3D Print.7z
- (2.17 MiB) Downloaded 434 times
Re: New Firmware I3proC_G02_V1.0.04_01
Thank you very much
Best greetings from saxonia!
Detlef
Best greetings from saxonia!
Detlef