MK4 Duo and A10M
MK4 Duo and A10M
Hi, someone have try to upload Kimbra on A10(M), if yes, what do you think about? I'm start to configure it, version 4.3.9, but I've a lot of to study, PID, LCD type (when I'll finish and test it O want to change lcd with Nextion 4.3") Any help about will be welcome
Re: MK4 Duo and A10M
Hi,Ricky1966
For the PID.
I think you can use the PID auto-tuning(If this firmware support)
You need to select the correct thermistor type.
But the big program is the LCD type(4.3" lcd).
You need to set the correct pin definitions for it.
For the PID.
I think you can use the PID auto-tuning(If this firmware support)
You need to select the correct thermistor type.
But the big program is the LCD type(4.3" lcd).
You need to set the correct pin definitions for it.
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: MK4 Duo and A10M
Hi William. I change my project, I want to change : board (arduino due and radds 1.6), lcd with Nextion (on github ther is a old project for Marlin) and maybe update extruder with cyclope (using mkr6); so I wait radds and after I start 