Geeetech

Here you can share you great ideas about hardware innovation. Here you can enjoy more professional and specialized services, Here is a platform for you to make a difference!
http://forum.geeetech.com/

Assemble the X-Z axis Problem

http://forum.geeetech.com/viewtopic.php?t=16071

Page 2 of 2

Re: Assemble the X-Z axis Problem

Posted: Wed Mar 18, 2015 5:17 pm
by zhangxueyou
It is inside the hole.
il est dans le trou

Re: Assemble the X-Z axis Problem

Posted: Sat May 23, 2015 8:32 am
by danger_dan46819
The threaded rods are 8mm (.311 inch in Diameter) I had to ream the holes out to .312" (5/16") so they would be round and rotate freely. Also lubricated the brass nut and the hole that was reamed. That quieted everything no more squeaking. My problem is I could not get anything to move until I moved the limit switches to the MIN pins not the MAX pin plugs.

Re: Assemble the X-Z axis Problem

Posted: Sat May 23, 2015 8:43 am
by zhangxueyou
danger_dan46819 wrote:The threaded rods are 8mm (.311 inch in Diameter) I had to ream the holes out to .312" (5/16") so they would be round and rotate freely. Also lubricated the brass nut and the hole that was reamed. That quieted everything no more squeaking. My problem is I could not get anything to move until I moved the limit switches to the MIN pins not the MAX pin plugs.
Yes, the endstops should be connected to MIN slots.
All times are UTC+08:00
Page 2 of 2

Powered by phpBB® Forum Software © phpBB Limited