Page 2 of 2
Re: Printing Quality
Posted: Tue Mar 24, 2015 2:41 pm
by leonardo.galardi@gmail.com
Hi,
I mean for layer height = 0.1 mm.
I've attached now the results that I forgot in my previous post
Re: Printing Quality
Posted: Tue Mar 24, 2015 2:44 pm
by zhangxueyou
Usually, the first layer height equal nozzle diameter.
You can see more details at this page:
http://manual.slic3r.org/
Re: Printing Quality
Posted: Tue Apr 21, 2015 11:44 pm
by Khilborn
I redid my entire calibration of the XYZ and I am still having a problem printing a test cube.
It looks like the problem is on the x-axis. The pulley's are tights and the belts are as tight as I can make them without them causing the extruder to start skipping.
Re: Printing Quality
Posted: Wed Apr 22, 2015 9:37 am
by zhangxueyou
Perhaps the filament does not stick to hotbed. Please try to smear a layer of glue, or spray a layer of hair sprayer.