Page 2 of 2
Re: Mightyboard Rev E wrong power connector
Posted: Wed Sep 02, 2015 9:41 am
by Mark
Hi, I don't see the pic here, have you post it ?
Re: Mightyboard Rev E wrong power connector
Posted: Wed Sep 02, 2015 10:02 am
by Mark
The voltage range of mightyboard is 12V-24V. Do you have pictures with all the wires connected?
Re: Mightyboard Rev E wrong power connector
Posted: Wed Sep 02, 2015 10:40 am
by fruity
Mark wrote:Hi, I don't see the pic here, have you post it ?
Try again. The picture upload utility was being flaky and limiting.
I removed all the wires because it wasn't working.
I tried the wires on my first Mightyboard the way that I was told to in this forum thread. And then I bought another board and I tried them the opposite way! Mind you, this is on a brand new power supply, straight from the original manufacturer.
If there is a way I can replace a capacitor or two and have a working board that would be great. Right now I am unsatisfied with Geeetech's product and am hesitant about buying a new board to try again.
I have two brand new OEM 12 V power supplies in addition to the Jameco 24 V power supply. I have two fried Geeetech Rev E boards and I have one broken original from Makerbot.
Re: Mightyboard Rev E wrong power connector
Posted: Wed Sep 02, 2015 11:03 am
by Mark
How about the chip here as the pic shows? It might be dead under24V. I'll contact you to solve this.