Page 2 of 3

Re: Y Axis Problem

Posted: Wed May 06, 2015 5:58 pm
by 3DPO
here it is

Re: Y Axis Problem

Posted: Wed May 06, 2015 6:03 pm
by zhangxueyou
Oh, your board type is GT2560. There's no jumper cap.
Then you should check if the printing model is amplified on y direction.

Re: Y Axis Problem

Posted: Wed May 06, 2015 6:23 pm
by 3DPO
can you tell me how I do that?

Re: Y Axis Problem

Posted: Wed May 06, 2015 6:43 pm
by 3DPO
model always look regular in repetier host.

Re: Y Axis Problem

Posted: Thu May 07, 2015 8:53 am
by zhangxueyou
Look at the picture, but please make sure all the switches under A4988 are on. The picture you show me is Z motor.
And please make sure the red wire of fan should be connected to "+", otherwise the fan will be dead.
QQ截图20150507084251.png
QQ截图20150507084251.png (22.46 KiB) Viewed 9857 times

Re: Y Axis Problem

Posted: Thu May 07, 2015 4:55 pm
by 3DPO
all the switches are on and the fan is plugged in. Please see the attached gcode and photo, scale of everything is set to 1. I did try setting the Y-axis to 0.25 which brought the print close to correct size. Can you tell me how to fix this?

Re: Y Axis Problem

Posted: Thu May 07, 2015 5:02 pm
by zhangxueyou
Sorry, but you forgot to upload the g-code file. If you can not upload, you should add it into a zip.

Re: Y Axis Problem

Posted: Thu May 07, 2015 5:18 pm
by 3DPO
here it is

Re: Y Axis Problem

Posted: Thu May 07, 2015 5:34 pm
by zhangxueyou
Please tell me the values of "X-steps/mm" "Y-steps/mm" and "Z-steps/mm" on LCD:
Control>Motion>Y-steps/mm

Re: Y Axis Problem

Posted: Thu May 07, 2015 5:46 pm
by 3DPO
see photo