Geeetech

Posted: **Fri Jul 10, 2015 4:23 am**

the GNB x-motor is 0.9 v now after i fixed it. it was 0.12 v.
I can move the x-motor with ease.

The PSU is at 21.3 V after i turn the power down from 24,8 V. the problem is that I can't turn it down any more.

Wrong cable input in the PSU?

Posted: **Fri Jul 10, 2015 4:45 am**

i Tested all the GND and the last one over the x motor input made sparks......

Posted: **Mon Aug 10, 2015 1:30 am**

i found the answer to why it doesn't work.

the X- Stepper Driver Module conduct no electricity.

I Changed places with the Y-Stepper Driver Module and the X-Stepper Driver Module and the x started gave 0.9 V and the Y 0.9 V.

Geeetech

x-axis onley goes to the left

Re: x-axis onley goes to the left

Re: x-axis onley goes to the left

Re: x-axis onley goes to the left